Braking is mainly controlled by the engine. Friction between a pair of pads and a rotating disc converts the kinetic energy of the vehicle into heat. High temperatures can be reached in the system which can be detrimental for both, components and passenger safety. Numerical techniques help simulate load cases and compute the temperatures field in brake disc and brake pads. The present work implements a Finite Element (FE) toolbox in Matlab/Simulink able to simulate different braking manoeuvres used for brake dimensioning mainly in the early phase of car development process. The brake pad/disc geometry is considered as an axisymmetric body assuming negligible temperature gradient along the circumference of the disc. Calibration using three control factors namely: heat coefficient during braking , acceleration  and emissivity  for the implemented thermal model is performed using experimental investigation at Volvo Car Corporation (VCC) for three specific severe load cases. The thermal model is extended to measure brake fluid temperatures to ensure no vaporisation occurs. Simulation results of the brake disc and brake pad show good correlation with the experimental tests. A sensitivity analysis with the control factors showed convective coefficient during acceleration  the most sensitive, with temperature change of around 16%.