In Atlas Copco a wide range of machines is produced from surface drill rigs, exploration drill rigs, underground drill rigs both for mining and construction to underground loader and haulers for mines. Recently new rock excavation methods have developed in cooperation with large mining companies. The machines are produced in low volume and often customized although having a modular approach. Time for validation is limited due to machines available for test are planned for customer delivery. It is on regular basis needed to validate and investigate vibrational behavior of installations as power packs and drivelines to get loads for simulation, identify resonances, operational deflection shapes, and vibration and stress levels for life length estimations under operational conditions. The time for a 40-180 Channel measurement is now down the range of 1-3 days. To reduce the time it takes to perform measurement a systematic approach has been taken that includes mainly three areas. First the Bookkeeping of all information and data needed for the analysis and reporting is input before or during the measurement. Systematic Approach of how to setup sensors, handle cable and equipment, planning and measurement. This includes practical examples of how to. Finally it is very important to take steps to assure Quality early in the measurement and also avoiding disturbances in the sensor path. There will be practical examples of important disturbances to look out for and quality check to perform. It should also be noted that the measurements is regular measured in mines or start up halls under rpm sweeps or/and operating conditions of the machines.